Author Topic: 93 KX 250 REAR FENDER? (Read 11034 times)

teamgreen500 · « **Reply #30 on:** February 06, 2004, 04:36:09 PM »

"F" as in "Forward"...

Manny

kx5ohio · « **Reply #31 on:** February 18, 2004, 12:02:00 PM »

Here's another from a noob...

attachment didn't work..

Fookeneh · « **Reply #32 on:** May 19, 2004, 12:01:56 PM »

93 UFO rear fenders are not availiable in the catalogue of my local dealer here in BC. What gives? Is White Bros another competetor ?

gowen · « **Reply #33 on:** May 19, 2004, 04:05:04 PM »

try dennis kirk

fast500#12 · « **Reply #34 on:** May 20, 2004, 09:14:48 PM »

im running a 2002 kx 250 rear fender. had to do quite a bit of trimming put it was well worth the effort. looks good if you getter right like i did.

mikesmith · « **Reply #35 on:** May 20, 2004, 09:50:49 PM »

Picture?

Fookeneh · « **Reply #36 on:** May 21, 2004, 07:10:18 PM »

02! were any mods required to the bike ,or just the fender? Does it fit snug against the underneath of the seat? thanks.

fast500#12 · « **Reply #37 on:** May 23, 2004, 12:34:27 PM »

no mods required to bike just lots of triming to the fender. there are some ribs on the top of the fender that you gotta trim and of course you gotta notch it for the pipe. i drilled a hole in the air box and installed a bolt with rubber washer for the lower attach point since it wont hit the air box mount screws. i will post picture when i put a new one on because i almost looped it yesterday and cracked the fender over half way though the with so its alittle floppy at the moment.

Author Topic: 93 KX 250 REAR FENDER? (Read 11034 times)

teamgreen500

kx5ohio

Fookeneh

fast500#12

mikesmith

Fookeneh

fast500#12