Author Topic: Slight crack/chip on cylinder port bridge?  (Read 1341 times)

0 Members and 1 Guest are viewing this topic.

Offline SweetTea

  • Jr. Member
  • **
  • Posts: 41
Slight crack/chip on cylinder port bridge?
« on: December 07, 2010, 02:53:10 PM »
I didn't have this little crack/chip before I sent my cylinder to US Chrome, but it came back with it.  It just looks like where a little bit of the weld came off during the plating process.  This isn't a problem is it?  Otherwise the cylinder is beautiful.  They had to plate it twice.  The first time around was no good, they got a blister in the plating, so they had to strip it down a second time and re-do it.  Last pic is just the pretty plating :D 

Thanks again.

http://i218.photobucket.com/albums/cc318/jjpruett1985/100_2646.jpg

http://i218.photobucket.com/albums/cc318/jjpruett1985/100_2648.jpg

http://i218.photobucket.com/albums/cc318/jjpruett1985/100_2650.jpg


Offline kaw rider

  • Hero Member
  • *****
  • Posts: 1,218
  • Cool your engine with water not fuel
Re: Slight crack/chip on cylinder port bridge?
« Reply #1 on: December 07, 2010, 03:46:42 PM »
is the plating lifting there or just a crack.

Offline SweetTea

  • Jr. Member
  • **
  • Posts: 41
Re: Slight crack/chip on cylinder port bridge?
« Reply #2 on: December 07, 2010, 03:53:31 PM »
Just a small crack, more like a chip.