General questions and advice..

[Lawnmowerman]

I did strange things before.. This is just a new project.
I did a couple of years of moped dragracing. Used a Puch Maxi single speed engine.
Made a Kawa KX85 cilinder on the origanal engine. Did 0 to 60 miles in 6.7 seconds..
Used a 85 cilinder because of the regulations that it's max 80cc with the origenal stroke of the engine.
Puch stroke is 43mm and with the 48.5mm bore made it close to 80.

Engine with a Ignitech programable ignition.
http://i29.tinypic.com/331dk3t.jpg
Youtube with homemade chassis..
http://www.youtube.com/watch?v=qmkk-B97D6Y
Complete homemade cilinderhead.
1
http://i41.tinypic.com/o7m05e.jpg
2
http://i43.tinypic.com/a2w32w.jpg
Because of the huge transfers i needed to weld a 3cm thick plate on the engine.
http://i41.tinypic.com/5f2czs.jpg
http://i44.tinypic.com/2vnndb8.jpg

[DoldGuy]

You might be a Redneck if?   

[GDubb]

I aint never seen no darned redneck with a diggity danged 'ol dragster moped you had to tune with one of those newfangled laptop computer contraptions... 


-G

[demographic]

Brilliant, keep the pictures coming.

[Lawnmowerman]

Yesterday the cylinder returned from Powerseal. Powerseal in the Netherlands to be precise.
Looks nice...


Now it's time to put the engine back together and calculate and cast a new cylinderhead. Were are going to use a 10mm sparkplug to minimize the disturbance. And we make sure there is room for the decompression valve.


Question..
I need a exhaust. One that's good in midrange and top-end.
What to get?
Low-end isn't that important. There wil be enough left to flip me over i think.