« previous next »
Pages: [1]   Go Down

Author Topic: Muffler question...  (Read 1953 times)

0 Members and 1 Guest are viewing this topic.

Offline IcemanK5

  • Full Member
  • ***
  • Posts: 80
Muffler question...
« on: September 14, 2009, 06:35:39 AM »
Hey folk's.

I'm going to repack a muffler. I would like to make it a bit quiter.

Question: Do you pack it loose or tight to make it quiter??

Thanks Kurt
Logged
The Nature of Man:
We spend 9 months trying to get out and the rest of our lives trying to get back in as many times as we can!

Ca. is like a chicken:
Put a fox in the hen house and you will have chicken dinner every time.

Offline Jopiz

  • Full Member
  • ***
  • Posts: 94
Re: Muffler question...
« Reply #1 on: September 14, 2009, 07:29:18 AM »
As tight as possible without being too tight. If you buy packing material from FMF or PC you should put everything in. I would recommend also sealing your muffler end cap with high heat resistant silicone.

-J
Logged

Offline IcemanK5

  • Full Member
  • ***
  • Posts: 80
Re: Muffler question...
« Reply #2 on: September 14, 2009, 08:14:49 AM »
Thanks J

Kurt
Logged
The Nature of Man:
We spend 9 months trying to get out and the rest of our lives trying to get back in as many times as we can!

Ca. is like a chicken:
Put a fox in the hen house and you will have chicken dinner every time.

Offline lumpy790

  • Jr. Member
  • **
  • Posts: 27
    • Moto Hose
Re: Muffler question...
« Reply #3 on: September 15, 2009, 11:13:07 AM »
While watching the FMF tech repack a muffler at Budds Creek I watched him and learned a trick. After wrapping the material around the muffler core tube he wrapped the packing with food wrap.....think Reynolds wrap.....it keeps the packing good and tight for installing into the muffler housing.
Logged
Pages: [1]   Go Up
« previous next »