« previous next »
Pages: [1]   Go Down

Author Topic: 91mm piston  (Read 2528 times)

0 Members and 2 Guests are viewing this topic.

maher

  • Guest
91mm piston
« on: April 20, 2008, 07:42:41 AM »
Hello!

Would I have to modify Kips, if I put 91mm wiseco piston in my kx500?
Logged

Offline don46

  • Hero Member
  • *****
  • Posts: 1,140
Re: 91mm piston
« Reply #1 on: April 20, 2008, 01:56:05 PM »
yes you would have to weld shut the flapper, the rotarty drums are fine, or you could use a pre-89 cylinder. Where are you going to find a 91mm piston?
Logged
Live today, for tomorrow may never come

Offline kaw rider

  • Hero Member
  • *****
  • Posts: 1,218
  • Cool your engine with water not fuel
Re: 91mm piston
« Reply #2 on: April 20, 2008, 02:06:37 PM »
why would you run a piston that big.
Logged

Offline kaw rider

  • Hero Member
  • *****
  • Posts: 1,218
  • Cool your engine with water not fuel
Re: 91mm piston
« Reply #3 on: April 20, 2008, 04:18:47 PM »
BDI
that would be easy to do. i would charge $250.00 to do that. that includes welding, but not replate.
Logged

Offline kaw rider

  • Hero Member
  • *****
  • Posts: 1,218
  • Cool your engine with water not fuel
Re: 91mm piston
« Reply #4 on: April 20, 2008, 08:56:57 PM »
i hope i don't get in trouble for posting this picture.
Logged

Offline kaw rider

  • Hero Member
  • *****
  • Posts: 1,218
  • Cool your engine with water not fuel
Re: 91mm piston
« Reply #5 on: April 21, 2008, 06:08:42 AM »
because this charger is the r&d stages. there making this for powersports industy.
Logged
Pages: [1]   Go Up
« previous next »