Author Topic: pipes  (Read 6643 times)

0 Members and 1 Guest are viewing this topic.

Offline maddoggy

  • Hero Member
  • *****
  • Posts: 711
  • K5 @ ST. ANTHONY DUNES
pipes
« on: November 11, 2007, 03:50:36 PM »
seems like alot of guys on here are running the fmf gnarly pipe. i run the fmf fatty gold "slightly bent but not dented" series just cause it came on the bike. i am considering getting a new pipe and would like to hear what pipe you like on your k5 and why. don't see alot of guys ,besides BDI,writing anything about pro-circuit even though they make good pipes. keyboards should be smoking this time.   MADDOGGY

stewart

  • Guest
Re: pipes
« Reply #1 on: November 11, 2007, 03:53:40 PM »
pro circut platuim pipe is the best i have tested,,  ps i own 2 to 3 of every k5 pipe i know off.. they made like 3 more horse than fmf gnally

Offline maddoggy

  • Hero Member
  • *****
  • Posts: 711
  • K5 @ ST. ANTHONY DUNES
Re: pipes
« Reply #2 on: November 11, 2007, 04:03:38 PM »
stewart, did the platinum pipe give the best performance throughout the power range or was it best in a paticular rev. thanks, MADDOGGY

Offline kx666

  • Sr. Member
  • ****
  • Posts: 352
Re: pipes
« Reply #3 on: November 11, 2007, 04:03:49 PM »
i run the stock pipe, it is made out of thicker material = less dents.

i dont have a dyno to back this but i feel that the stock pipe w/ out dents is better then the PC (the pipe i think preferms the best) with dents.

has anyone run a dyno to compair?>

stewart

  • Guest
Re: pipes
« Reply #4 on: November 11, 2007, 04:12:53 PM »
pro circut pipes  have apperantly had a lot of r and d on the k5.. they have to be properly jetted etc  but run the best through out the power range

Offline kx666

  • Sr. Member
  • ****
  • Posts: 352
Re: pipes
« Reply #5 on: November 11, 2007, 04:53:34 PM »
i do like some of the FMF silencers

Offline Arnax

  • Jr. Member
  • **
  • Posts: 22
Re: pipes
« Reply #6 on: November 16, 2007, 06:00:23 PM »
I replaced the stock pipe with a PC works. Like Stewart said, it runs better throughout. I don't feel I lost any bottom end and the bike is definitely snappier (not sure that's a word ;)). My jetting was a bit rich for the stock pipe, but is perfect for the PC.

Offline Hillclimb#42

  • Hero Member
  • *****
  • Posts: 991
  • '97 kx 500, '96 kx 250, '99 KTM 380
Re: pipes
« Reply #7 on: November 19, 2007, 10:07:21 AM »
Pro Circuit Platinum works great and I have the Fmf silencer on it. Hits hard everywhere.

Offline moreccsthanlbs

  • Jr. Member
  • **
  • Posts: 39
Re: pipes
« Reply #8 on: November 19, 2007, 11:07:27 AM »
i have a fmf gnarly 'desert' pipe...i would highly reccomend it

2000desertkx500

  • Guest
Re: pipes
« Reply #9 on: November 19, 2007, 12:25:08 PM »
I have used the FMF gnarly desert. I am currently running the procircuit. Both are great. I like the PC a little more.

Offline Uzi9mm

  • Full Member
  • ***
  • Posts: 166
Re: pipes
« Reply #10 on: November 22, 2007, 07:10:02 AM »
I have a FMF Gnarly.  Bike came with it, so I haven't tried anything else.  I would like a Pro Circuit.  My bike seems a little flat on the top end.   :|
Fear the government that fears your gun.

arleybeer40

  • Guest
Re: pipes
« Reply #11 on: November 26, 2007, 07:37:44 PM »
I've only run a procircuit pipe on mine. I've had both the works and the platinum and the only difference i noticed between the 2 is the platinum seems to run a little cooler on the surface tmps. also its easier to keep looking good. with the works pipe you always have to clean it to keepit lookin good.

Offline maddoggy

  • Hero Member
  • *****
  • Posts: 711
  • K5 @ ST. ANTHONY DUNES
Re: pipes
« Reply #12 on: January 21, 2008, 04:47:07 PM »
pro circut platuim pipe is the best i have tested,,  ps i own 2 to 3 of every k5 pipe i know off.. they made like 3 more horse than fmf gnally

stewart, were you refering to the PC platinum or the platinum2. and by the way, how did it compare performance wise to the PC works pipe?     MADDOGGY

Offline doordie

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 775
  • Do or Die.....
Re: pipes
« Reply #13 on: January 22, 2008, 12:55:02 AM »
I use PC at trailriding/enduro and DOMA for supermoto.
More "hit" in DOMA and more topend....
All aftermarket pipes works good BUT it depends what portduration you use which
one working best for your ridingstile or track. :wink:
Iceroad champion 2006,still 2007,even 2008 without a single race!

Offline doordie

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 775
  • Do or Die.....
Re: pipes
« Reply #14 on: January 22, 2008, 12:58:09 AM »
I use PC at trailriding/enduro and DOMA for supermoto and iceroadracing.
More "hit" in DOMA and more topend....
All aftermarket pipes works good BUT it depends what tuning and portduration you have which one working best for your ridingstile or MX/enduro/supermoto. :wink:
Iceroad champion 2006,still 2007,even 2008 without a single race!