Spur Gear Bearing help? W/picture

[budryzer]

Greetings All,
   I have a manual and I used the search feature but I'm in need of a link.  Milky Oil, so I checked and found this groove in my spur gear shaft.  I ordered two new bearings, shaft and seals.  My question is my manual doesn't show this '93 type of install.  Do I install the bearings in the case and then press in the spur gear?  It appears that my existing spur gear is a tolerance fit.....   Also, I should have two seals and two bearings, correct?
Any link to a thread on this would be helpful to me.

Thanks

[budryzer]

Well, I got the seal.  It's just one wide seal, that is open on each side to keep one fluid away from the other.  They don't play well together
Bearings and spur should arrive this PM in the mail.

My mailman shows up after 5pm here.......

[dave916]

Marking {writing] on seals towards the bearings
Make sure to grease seal lipps

[budryzer]

Yup, Thanks.  Just put it in.  New spur and bearings as well.  Should put the bike back together tomorrow:)