Author Topic: Cold Start  (Read 5782 times)

0 Members and 4 Guests are viewing this topic.

mikesmith

  • Guest
Cold Start
« Reply #15 on: April 24, 2005, 08:04:51 PM »
I just kick it through slowly a few times and it works great.

Offline 5dracing

  • Full Member
  • ***
  • Posts: 209
Cold Start
« Reply #16 on: April 24, 2005, 11:10:52 PM »
For what it's worth here's my cold start method. 1. Lay bike over until gas runs out the overflow. 2. Put bike in second gear and rock back and fourth to get some fuel in the cylinder. 3. Pull choke up. 4. Get all 240lbs of me in a downward motion on the kick starter. Generally works on the first or second kick.

I believe the most important thing is to get some fuel in the cylinder.
The torch has been passed; Father to Son. He is faster!!!

orderofsion

  • Guest
cold starting
« Reply #17 on: April 24, 2005, 11:47:58 PM »
for what its worth mine usualy takes about 6 or 7 kicks to start but I've been trying a few carbs over the past couple of days and yesterday I had a float stick and flood petrol everywhere presumably into the engine as well and when I went to start it it fired up on the very first half hearted kick ! Flooding may be the way to go although I've heard that too much juice in your cases can pop out the flywheel side oil seal as the compression gets critical .

BrianSM

  • Guest
Cold Start
« Reply #18 on: May 11, 2005, 05:51:32 PM »
I lean bike over to watch fuel....full choke, a little throttle and top dead center and she fires n the first kick cold almost always......