Author Topic: magura jack  (Read 2856 times)

0 Members and 1 Guest are viewing this topic.

biscuit

  • Guest
magura jack
« on: March 22, 2003, 02:40:47 PM »
Greetings from the great white north. Snows melting and i,m getting pumped. check out Magura,s "JACK" [ hydraulic clutch kit] which is available for kx500,s . www.magurausa.com                                                                        Godbless your troops and godspeed

husqrider

  • Guest
magura jack
« Reply #1 on: March 24, 2003, 02:57:45 AM »
I have a Magura clutch on my '97 500 works good  I recently tried the cable re-routing idea that was posted somewhere in the forum and have found it to work just as well as the Magura hyd clutch. If you do go for a Magura , watch the alignment of the pull rod on the slave cyl. going to the clutch arm on the engine. It needs some finesing to pull straight. Magura sends a little drawing that shows cleaning up the clutch arm with a Dremel tool but that is not enough. I have broken a pull rod on a slave cyl and had to have Magura send me a new one , a little bit of a pain.