working on getting my bike tuned in..

[conbread]

well after reading up on crank seals.. with my jetting being so lean and the plug looking so black and feeling BLUBBERY for 1/2 throttle id say i prob need to pull it apart and replace them and the bearings....

[conbread]

any part numbers for a good set??

[Motorrad]

any part numbers for a good set??

cometic.

[conbread]

Motorrad whats your opinion on all this?
what about the bearings while i have it apart?

[Foxx4Beaver]

OEM numbers are...

92045-1027 Crank bearings

92050-057 Seals

If you can afford it....you should just replace every bearing and seal while you're in there...then you know what you have,and should be good for quite a while.

[conbread]

yea i should have done it while i had the top end off lastweek, but hey this is still way cheaper than all of my turbo and blower mustang stuff.. hahahah

[Motorrad]

Motorrad whats your opinion on all this?
what about the bearings while i have it apart?

somone that reads my build thread more than I do should link over to the bearing section.   (sandblaster?)

I believe its in the first few pages?

[Motorrad]

here ya go

http://www.kxriders.com/forums/index.php/topic,8717.msg67413.html#msg67413

[sandblaster]

Sorry, I was enjoying a fire, friendship, and social lubricants.... Or I would have been happy to post the link...
Yes I read it a lot and learn something new every time,
Thanks Motorrad

[conbread]

video is posted in the video section...