« previous next »
Pages: [1]   Go Down

Author Topic: triple clamps  (Read 2189 times)

0 Members and 3 Guests are viewing this topic.

Offline Moded331

  • Newbie
  • *
  • Posts: 3
triple clamps
« on: March 09, 2012, 10:26:26 AM »
I picked up a 97 kx125 not to long ago, and have been trying to find a set of aftermarket triple clamps.  I dont like the cast in bar mounts, but dont just want to change the upper.  The problem is that I cant find an after market lower for the 125/250.  I did find one for the 500 thouh for a 97 and up.  Would that work?
Logged

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: triple clamps
« Reply #1 on: March 10, 2012, 04:11:10 AM »
Hello.
Measure your clamping diameter the compare to this KX500 Chart, you will need to scroll to the right to find the fork info:
http://oem-cycle.com/KAWASAKIKX500BIKEID.aspx
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Moded331

  • Newbie
  • *
  • Posts: 3
Re: triple clamps
« Reply #2 on: March 10, 2012, 07:22:33 AM »
Thanks for the link.  Lots of good info on there.  I figured that the fork  would fit in the clamp, but wasnt sure if the offset was the same?  That and if the stem hole was the same size or not? The clamping area is only a 0.1mm difference in diameter,  so that shouldnt be a problem.
Logged
Pages: [1]   Go Up
« previous next »