Author Topic: what to do.....  (Read 2761 times)

0 Members and 1 Guest are viewing this topic.

Offline maia-papaya

  • Jr. Member
  • **
  • Posts: 16
what to do.....
« on: February 01, 2011, 05:43:03 AM »
Hey y'all. I own a '03 kx125 and need input for "basic,necessary" mods for woods riding, besides protection. If anyone has info would be appreciated.  (flywheel, pipe etc.)

Offline Nairns_Two_50K

  • Jr. Member
  • **
  • Posts: 22
Re: what to do.....
« Reply #1 on: February 01, 2011, 05:59:37 AM »
Skid plate would be good insurance! Where I ride it is a must.

Offline stevea100m

  • Full Member
  • ***
  • Posts: 123
Re: what to do.....
« Reply #2 on: February 01, 2011, 06:15:49 AM »
I ride my 03 kx 125 in the woods ALOT. I put an FMF SST pipe on it which broadens the whole power range. I had the FMF fatty but the SST is much better. The best upgrade i did to the bike was overbore it 80 over. The main reason I overbored it was because the way it was stock was very flat. I aslo had a slot put in the back transfer port that runs from the bottom of the transfer port down to about 7/16th of an inch to the bottom. I got the slot trick strait from team green off road. Once I overbored it it brought the entire motor alive and gave the bike much more bottom end. I also Have a 3.1 gallon IMS tank, 13 and 49 gearing, I also had the suspension revalved for an all around setup since I use it for Motocross harescrambles and enduros. With the over bore I tend to run a 120 rear tire and it doesnt seem to hinder it.

Offline jonny500

  • Hero Member
  • *****
  • Posts: 580
Re: what to do.....
« Reply #3 on: February 01, 2011, 06:48:58 AM »
v force reeds are a quick cheap way of getting a good power gain across the rev range

Offline maia-papaya

  • Jr. Member
  • **
  • Posts: 16
Re: what to do.....
« Reply #4 on: February 01, 2011, 07:09:36 AM »
sweet! Anyone throw a 7oz flywheel on?
« Last Edit: February 01, 2011, 10:27:09 AM by maia-papaya »