Author Topic: KX500 LIGHTING  (Read 3458 times)

0 Members and 1 Guest are viewing this topic.

Offline JBKX

  • Full Member
  • ***
  • Posts: 70
KX500 LIGHTING
« on: March 01, 2003, 02:18:20 AM »
I HAVE A 1986 KX 500 AND I'M WANTING TO PUT A LIGHTING COIL ON IT.  IHAVE TALKED TO RICKY STATOR AND HE SAYS THEY DON'T MAKE A LIGHTING COIL FOR THE 86.  TEAM GREEN MATED A TECATE 3 WHEELER STATOR, FLYWHEEL AND CDI ONTO THE KX500 TO RACE BAJA.  DOES ANYONE KNOW HOW THEY DID IT?  I HAVE TRIED THE TECATE FLYWHEEL ON MY CRANK AND THE TAPER DOESN'T SEEM THE SAME.  THE FLYWHEEL BOTTOMS OUT ON THE ENGINE CASE.  ANY INFO IS GREATLY APPRECIATED.
2) 1986 KXT250 TECATE 3's
1986 KXT500 TECATE
2001 KX500SF

kxtaz

  • Guest
lighting 89kx500
« Reply #1 on: March 19, 2003, 03:51:45 PM »
i put lights on a 89kx500 i had to upgrade my flywheel and stator plate to a 90 or newer setup found the parts cheap on ebay i used my stock cdi and flywheel cover hopefully this will work for a 86 don't know if it is same as my 89kx500 last thing to buy is the lighting coil my complete setup cost me $250 including headlight and taillight

KXT500

  • Guest
KX500 LIGHTING
« Reply #2 on: March 19, 2003, 04:26:26 PM »
i have several tecate stator and flywheels. they are junk. i put a kx250 ignition on my tecate. the tecate magnets are glued on and break off. i bet the vibration on a kx500 will destroy them in no time. i also have 86kx500 so i hope you figure out a solution, i want lights too.  8)