« previous next »
Pages: [1]   Go Down

Author Topic: linkage and swingarm bearing installation  (Read 2497 times)

0 Members and 1 Guest are viewing this topic.

Offline tommytwo

  • Newbie
  • *
  • Posts: 1
linkage and swingarm bearing installation
« on: April 05, 2012, 01:04:24 PM »
Hi KX'ers. Was wondering if anyone had a diy layout on how to install linkage and swingarm bearings on 2003 KX 125.

Cheers!
Logged

Offline royceymon@hotmail.co.uk

  • Sr. Member
  • ****
  • Posts: 298
Re: linkage and swingarm bearing installation
« Reply #1 on: April 09, 2012, 07:12:25 AM »
diy : sockets and studding with nuts and washers i have used when i hadnt the tools with me this was an emergency job though! otherwise solid bar on the lathe ,press out, worst case drill lathed up parts and use studding ,two spanners etc!
Logged
Pages: [1]   Go Up
« previous next »