Another Project!!

[edgar_kx3]

Now i can POST my pics !!!

[edgar_kx3]

UPDATE!!!! i started on my 500af this evening, have the engine in the frame. I cut out the old motor mounts, and the down tube, going to start building my mounts tomarrow!!! will keep you all updated, i will try to have pics up tomarrow!!!

[edgar_kx3]

The project is started

[edgar_kx3]

My 500af, fitting the service honda exhaust to my chassis!!!!

[kxpegger]

Looking good! Invert your cylinder hose connection and get the 180 degree Service Honda radiator hose too! Gives you all the clearance you need next to the pipe.

[edgar_kx3]

how much does the hose kit cost??? also i have a problem with my kickstart, it bottoms out on the frame before it gets the the peg!! how is the fix, do you have to space the kickstart out or what???

[jfabmotorsports.com]

The fix! 

JFAB

[kxpegger]

how much does the hose kit cost??? also i have a problem with my kickstart, it bottoms out on the frame before it gets the the peg!! how is the fix, do you have to space the kickstart out or what???

Mine did that too from Service Honda. About 60 thousandths with a Dremel took care of the problem. JFab's picture shows much more removed but whatever works. Every frame and motor combo is going to be slightly different with different requirements for clearances.

[edgar_kx3]

very NICE!! thanks for the advice , that was the route i was guessing but wasnt sure..get mine fixed up tomarrow, going to get everything welded next week, will get some pics up when i get it done!!

[The Flyin Hawaiian]

Would anybody happen to have a picture of the airbox boot to airbox mounting? I did mine last night and would like to see how everyone else did theirs.

[edgar_kx3]

AJ if you are out there how do i get the service radiator hoses for my kx500af???

[elemeno187]

Bad machines here!!!

[patz]

Edgar:

I'm interested in purchasing your KX500 rolling chassis.  Any interest in selling it?  Where are you located?

pat

[edgar_kx3]

sorry pat already sold it. i do have a cr500af on ebay right now if you are interested!

[patz]

Thank you anyway.  I'm putting together an F450 moto style kx500 roadracer.  I already have my motor ( i initially tried to put it into a TZ250 chassis) and need some chassis pieces.