Author Topic: k5 running funny  (Read 2320 times)

0 Members and 1 Guest are viewing this topic.

Offline 500freak

  • Full Member
  • ***
  • Posts: 53
k5 running funny
« on: August 05, 2009, 06:27:40 PM »
ok other problem, when crusing the road at low rpm it cuts out and misses alittle. you have to give it at least half throttle before it straightens out. but then better be holding on!!!!!!
87 k5 Pc pipe,v-f3,pwk....SOLD!!
87 k5 stage 3 port,torque spacer 39.5mm carb,gnarly pipe,vf reeds,uni filter,bored 86.5
99 banshee 421 stroker beast!!!
75 dt400 all stock SOLD!
85 kx125 stock

Offline dangerous dean

  • Jr. Member
  • **
  • Posts: 43
Re: k5 running funny
« Reply #1 on: August 05, 2009, 06:39:22 PM »
sounds like a normal 2-stroke just needing a clear-out of excess oil

Offline KX500freak

  • Hero Member
  • *****
  • Posts: 1,028
  • KX500 - Have a Wheelie good weekend
Re: k5 running funny
« Reply #2 on: August 05, 2009, 09:29:32 PM »
hmm,it sounds like jetting is off ,maybe clogged ,airfilter clean?
what jets you run in the carb ,which altitude you,re at
maybe floatheight too high ,and maybe petcock filter clogged.
also kips not overrotating ? it obstructs exhaustflow at low rpm


it should take off like a missile with a twist of the wrist,not like yours does,
i had once issues like you ,i downsized the pilotjet one size 60>58
that solved my issue ,did yours smoke too when it was cutting out on you?

 
Dutch Team Green 91-94-01 KX500

Offline 500freak

  • Full Member
  • ***
  • Posts: 53
Re: k5 running funny
« Reply #3 on: August 06, 2009, 04:47:19 AM »
well my kips is fine i checked it. i dont know what the jetting is.  i bought it and never changed it. it doesnt smoke that much i mix 40-1. when its cold it smokes but seems normal.
87 k5 Pc pipe,v-f3,pwk....SOLD!!
87 k5 stage 3 port,torque spacer 39.5mm carb,gnarly pipe,vf reeds,uni filter,bored 86.5
99 banshee 421 stroker beast!!!
75 dt400 all stock SOLD!
85 kx125 stock

Offline Atrain

  • Newbie
  • *
  • Posts: 8
Re: k5 running funny
« Reply #4 on: August 06, 2009, 12:35:38 PM »
Mine ran just like that when I got it. It was too rich. I adjusted the needle/clip and and then fine tuned with the air screw, now it runs perfect.

Go to KX500 General Specs / Tuning Tips then click on KX jetting 2003. It explains what adjustments affect what part of the throttle. That's what I did. Good luck!
« Last Edit: August 06, 2009, 12:42:40 PM by Atrain »