« previous next »
Pages: [1]   Go Down

Author Topic: Crank Seals ???  (Read 1629 times)

0 Members and 1 Guest are viewing this topic.

KX Newfie

  • Guest
Crank Seals ???
« on: October 17, 2008, 02:52:32 AM »
Bearings seem good......but seal on clutch side definately gone.....should i do a complete tear down & change bearings anyway.....or just change seals.

I may change bearings as well (hard to tell if bearings are perfect when the cases aren't split.}  :|
Logged

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Re: Crank Seals ???
« Reply #1 on: October 17, 2008, 03:40:17 AM »
the cases need to be split to change those seals. Before those seals can be replaced the crank bearing will need to be pressed out of the cases, so I would replace everything while in their.
Logged
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

KX Newfie

  • Guest
Re: Crank Seals ???
« Reply #2 on: October 17, 2008, 03:51:57 AM »
Right on....haven't been inside the K-5 before {figured i could get the seals from clutch & mag sides}
No biggy, she shall be done  :-D
Logged
Pages: [1]   Go Up
« previous next »