« previous next »
Pages: [1]   Go Down

Author Topic: Kx250 rear brake keeps seizing  (Read 2770 times)

0 Members and 1 Guest are viewing this topic.

Offline Hmfc83

  • Newbie
  • *
  • Posts: 2
Kx250 rear brake keeps seizing
« on: December 21, 2016, 05:19:06 AM »
Hi my kx250 1999 model rear brake keeps seizing up after a few hours of use. I've renewed the calaper piston brake pads brake fluid the lot but still it locks up could there be a problem with the master cylinder ? Or if that was failing would I have no brakes any help ? 
Logged

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: Kx250 rear brake keeps seizing
« Reply #1 on: December 21, 2016, 05:24:42 AM »
it sounds like the caliper needs to be completely disassembled, and thoroughly cleaned/inspected, and be sure you don't need to replace any parts.
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: Kx250 rear brake keeps seizing
« Reply #2 on: December 21, 2016, 05:32:24 AM »
a rebuild kit for the master wouldn't hurt...I've found it's best to use oem parts when rebuilding masters, on a couple occasions.

be sure your brake pedal is moving freely/smoothly on the pivot pin too....any sand or corrosion, can cause issues as well.
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline Hmfc83

  • Newbie
  • *
  • Posts: 2
Re: Kx250 rear brake keeps seizing
« Reply #3 on: December 21, 2016, 05:53:28 AM »
The calaper was total stripped and cleaned the peg seems fine. It's like it over heats and locks solid for about 10/15 mins then it will fully release and I can nurse it back to the van. I could get a replacement seal for the master cylinder tonight but won't be able to fit it till tomorrow and then wait for a break in the weather to try it out but many thanks for the reply 👍🏻
Logged
Pages: [1]   Go Up
« previous next »