« previous next »
Pages: [1]   Go Down

Author Topic: 94 KX250 Idle screw  (Read 2601 times)

0 Members and 1 Guest are viewing this topic.

Offline GRARA

  • Full Member
  • ***
  • Posts: 69
94 KX250 Idle screw
« on: December 01, 2015, 09:09:56 PM »
Looking for some help....again, when i turn the idle screw on my carb it makes no difference!
Is this a problem with my carb or something else????
Logged

Offline umberto

  • Administrator
  • Hero Member
  • *****
  • Posts: 2,488
  • First Ride 02-02-19
Re: 94 KX250 Idle screw
« Reply #1 on: December 01, 2015, 11:39:43 PM »
On my 88 carb, the idle screw had fallen out, and the guy just replaced it with a short bolt. I would recommend backing yours out, and making sure it matches the parts fiche for your year. 
Logged
Perhaps I have a dirt bike addiction?

03 KX 250/88 KX 525/2017 KX250F - Goliath
17 KX250F/04 KX250
04 KX 250 - Lunchbox's Bike
05 KX 125/144

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: 94 KX250 Idle screw
« Reply #2 on: December 02, 2015, 12:23:03 AM »
you could need a different pilot jet...how many turns out is your air screw?...see if running it with the choke on makes any difference.
when was the last time you checked the reeds?....reeds that don't sit flat and tight to the cage can cause it too.
I've seen some bikes that won't idle until they've been FULLY warmed up too.
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline GRARA

  • Full Member
  • ***
  • Posts: 69
Re: 94 KX250 Idle screw
« Reply #3 on: December 02, 2015, 01:09:34 AM »
Thanks for the replys....it used to adjust no problem,ive just had the barrel re-plated and fitted a new carb boot dont no if thats got anything to do with it, the reeds DO have a slight gap...can i turn them over? seem to remember doing this on my old KTM???
Logged

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: 94 KX250 Idle screw
« Reply #4 on: December 02, 2015, 01:12:02 AM »
if the reeds have gaps, that's not good.
you can try flipping them, you might get lucky, but don't be surprised if you end up having to buy new ones.
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ
Pages: [1]   Go Up
« previous next »