« previous next »
Pages: [1]   Go Down

Author Topic: water pump shaft  (Read 2209 times)

0 Members and 1 Guest are viewing this topic.

Offline gwcrim

  • Hero Member
  • *****
  • Posts: 673
    • http://profiles.yahoo.com/gwcrim
water pump shaft
« on: April 05, 2014, 10:41:12 AM »
I got new bearings in the cover now.  The new issue is the pump shaft.  It's a very tight fit, like a press fit.  How do I know the correct depth?  Does it butt up against the bearing?
Logged
~Crim~
You raise the blade
You make the change
You rearrange me 'til I'm sane

Offline wardro

  • Newbie
  • *
  • Posts: 9
Re: water pump shaft
« Reply #1 on: July 19, 2014, 09:19:25 AM »
I have the same problem trying to remove mine.  I used a brass punch and hammer and gently tapped on it and nothing happens.  I'm afraid to beat it out.  Any suggestions?   
Logged

Offline Pmcg

  • Sr. Member
  • ****
  • Posts: 352
Re: water pump shaft
« Reply #2 on: July 19, 2014, 10:56:00 AM »
My shaft was worn so I just ordered a new one. It wasn't expensive and with new bearings it pressed in pretty easy. I used the old one as a gauge for how far to press it in.  Here's a picture of the wear.
Logged

Offline wardro

  • Newbie
  • *
  • Posts: 9
Re: water pump shaft
« Reply #3 on: July 19, 2014, 02:36:39 PM »
Did you use some type of press or a punch to install/uninstall.   Also is there some common place to order these parts or do you just OEM through some place like Motosport.com
Logged
Pages: [1]   Go Up
« previous next »