Author Topic: To replace cast piston or not?  (Read 2406 times)

0 Members and 1 Guest are viewing this topic.

Offline NZ500

  • Full Member
  • ***
  • Posts: 72
To replace cast piston or not?
« on: December 22, 2011, 12:37:36 PM »
I have a stock cast piston in my '90 k5. The cylinder has been sleeved and measures up like new (86.03). The piston looks like it's had quite a bit of use but only measures 85.90mm. The Clymer book says new is 85.905-85.920. So it's only just out of new specs. Service limit is 85.76.

Are the specs in book ok to go off? 85.76 seems like a lot of wear for service limit?

I've spent a lot of money and time on this and just not sure how safe it is to run. At least there isn't to much piston to bore clearance? Would it be possible that the piston is a used one off an earlier KX that is bigger from new?

Offline bleeding green

  • Jr. Member
  • **
  • Posts: 49
Re: To replace cast piston or not?
« Reply #1 on: December 22, 2011, 11:37:18 PM »
if you have already spent big money on this then why not be safe and put a new piston in. seems like cheap insurance to me. just my 2 cents. good luck and happy holidays!

Motorrad

  • Guest
Re: To replace cast piston or not?
« Reply #2 on: December 23, 2011, 01:28:52 AM »
do a quick search on here regarding what happens when cast pistons get to the end of their service life...   :-o :-o


Motorrad

  • Guest
Re: To replace cast piston or not?
« Reply #3 on: December 23, 2011, 01:29:53 AM »

Offline NZ500

  • Full Member
  • ***
  • Posts: 72
Re: To replace cast piston or not?
« Reply #4 on: December 23, 2011, 08:31:44 AM »
Thanks for your replies.

Re bleeding green, sounds like a good idea. It's just gotten rediculous is all.

Yeah I've already seen the horrible pictures, other wise I wouldn't have been concerned about running it. The piston and bore does measure up close to new specs is the odd thing. The piston had bad blow by marks. I wonder if it had a guts full of sand or was used before the cylinder was sleeved. I'll swap it out because I couldn't handle having this blow up now.

Did the Wiseco pistons ever get that cavity on the outside removed or was it just the custom ordered ones with the window in them?

Thanks and enjoy your Christmas.

Offline Polar-Bus

  • Hero Member
  • *****
  • Posts: 1,023
Re: To replace cast piston or not?
« Reply #5 on: December 24, 2011, 12:54:12 AM »
I've spent a lot of money and time on this and just not sure how safe it is to run.

This is your most important comment. Far too many people "jump over a dollar to save a dime" . Replace the piston and ride worry free thereafter.
01' KX500
'84 GPz1100
'87 GSX-R  750
'06 HD Fatboy
'73 Kawi H1
'03 CRG KX500 Shifter kart

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: To replace cast piston or not?
« Reply #6 on: December 24, 2011, 02:10:34 PM »
+1  8-)
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.