« previous next »
Pages: [1]   Go Down

Author Topic: what is this  (Read 3719 times)

0 Members and 1 Guest are viewing this topic.

Offline chrisxj

  • Full Member
  • ***
  • Posts: 51
what is this
« on: September 02, 2011, 06:33:44 PM »
  I was startin the tear down on the k5 and came along this contraption what is it or should i say what does it do i never seen somthin like this before
Logged
1989 zuki 500 zilla mx ported DR.Q pipe undercut gears and 41.5mm mikuni

85/86 KX500 death trap (restore)maybe

1986 honda XL600r all stock and red white and blue

Offline kwakman

  • Hero Member
  • *****
  • Posts: 879
  • Kwikasfuki KX500
Re: what is this
« Reply #1 on: September 02, 2011, 08:57:14 PM »
that be a boost bottle.gives engine  somewhere to store extra inlet charge before throttle openings.all 85 500s got them....
Logged
And lo, I did loft the front wheel and carried it forth to the unbelievers, and cast it down before them and said unto them ''look now upon the might of my throttle control ye pitiful cretinous ones''
And the unbelievers did quake in their boots....

Offline Polar-Bus

  • Hero Member
  • *****
  • Posts: 1,023
Re: what is this
« Reply #2 on: September 02, 2011, 10:06:34 PM »
Quote from: kwakman on September 02, 2011, 08:57:14 PM
that be a boost bottle.gives engine  somewhere to store extra inlet charge before throttle openings.all 85 500s got them....

Yup, good eye. "Boost bottles" were a short lived fad performance gimmick back in the mid 80's . DG made them aftermarket and everyone (myself included) realized that after you drilled a large hole in your intake boot for the boost bottle nipple, the boot would tear and crack from vibration and then you suck air, lean out and your piston goes "SQUEEEEK" .
Logged
01' KX500
'84 GPz1100
'87 GSX-R  750
'06 HD Fatboy
'73 Kawi H1
'03 CRG KX500 Shifter kart

Offline chrisxj

  • Full Member
  • ***
  • Posts: 51
Re: what is this
« Reply #3 on: September 03, 2011, 02:58:19 AM »
  When i start rebuilding it it will need a new boot it is cracked to hell i dont know how ran with out suckin air but it did. should i put it back on or can i get away with ditchin it its jerryrigged on their anyways because its and 86 frame
Logged
1989 zuki 500 zilla mx ported DR.Q pipe undercut gears and 41.5mm mikuni

85/86 KX500 death trap (restore)maybe

1986 honda XL600r all stock and red white and blue

Offline kwakman

  • Hero Member
  • *****
  • Posts: 879
  • Kwikasfuki KX500
Re: what is this
« Reply #4 on: September 03, 2011, 04:30:55 AM »
ditch it.use 86 manifold, as 87 on have an angled manifold due to different shock location than 83 thru 86.hth.K.
Logged
And lo, I did loft the front wheel and carried it forth to the unbelievers, and cast it down before them and said unto them ''look now upon the might of my throttle control ye pitiful cretinous ones''
And the unbelievers did quake in their boots....

Offline Polar-Bus

  • Hero Member
  • *****
  • Posts: 1,023
Re: what is this
« Reply #5 on: September 03, 2011, 11:09:02 PM »
Quote from: kwakman on September 03, 2011, 04:30:55 AM
ditch it.use 86 manifold, as 87 on have an angled manifold due to different shock location than 83 thru 86.hth.K.

Great advise ! :wink:
Logged
01' KX500
'84 GPz1100
'87 GSX-R  750
'06 HD Fatboy
'73 Kawi H1
'03 CRG KX500 Shifter kart

Offline dave916

  • Hero Member
  • *****
  • Posts: 546
Re: what is this
« Reply #6 on: September 04, 2011, 04:06:31 AM »
Quote from: kwakman on September 03, 2011, 04:30:55 AM
ditch it.use 86 manifold, as 87 on have an angled manifold due to different shock location than 83 thru 86.hth.K.

the 86on manifold wont fit the 85  { 4bolt vs 6 bolt }
a new 85 manifold should be very reliable as the hole for the boost bottle is oem {not drilled}
the boost bottle is suppose too improve lowend power and MPG
Dont know how well they work but i dont think all the big maufacturers would spend the extra cash fitting them if they did not work
yamaha first Yamaha Energy Induction System (YEIS) used on many models from the 70/90s and still used it on some of the later ypvs models dt125 rd125etc where the gains should be less
 Suzuki Intake Pulse Control system (SIPC), have used on many model ts rgv
not sure what honda called there system but i think the boost bottle was fitted too some NSRmodels 

if you do remove the boost bottle on the kx you may need to rejet,   
Logged

Offline kwakman

  • Hero Member
  • *****
  • Posts: 879
  • Kwikasfuki KX500
Re: what is this
« Reply #7 on: September 06, 2011, 03:20:39 AM »
Everyday's a school day....looks like you need to find an 85 manifold then, or have jfab do you an ally one... :evil:K.
Logged
And lo, I did loft the front wheel and carried it forth to the unbelievers, and cast it down before them and said unto them ''look now upon the might of my throttle control ye pitiful cretinous ones''
And the unbelievers did quake in their boots....

Offline kelcrist

  • Full Member
  • ***
  • Posts: 52
Re: what is this
« Reply #8 on: November 25, 2011, 05:09:32 AM »
i feel the boost bottle and similar devices are definitely a gimmick. on my 91 WR500 i had all the parts to convert it to a YZ. doing so meant not running the boost bottle that was stock with this bike. i never noticed any difference whatsoever in how the engine ran with it or without it.    same can be said for my IT200.    i would definitely remove it and make sure the manifold is well sealed.    another opinion for you to consider hahaha................
Logged
Pages: [1]   Go Up
« previous next »