Author Topic: PVL ignition (Read 2357 times)

delusionised · « **on:** June 21, 2005, 04:39:36 PM »

Tell me about this product, what does it do? can I put it on a stock KX5, Is it hard to put on or should I have a professional do it? is there any thing I would have to change like jetting or plugs? and lastly How much is it? thanks for any input...

gowen · « **Reply #1 on:** June 21, 2005, 05:35:17 PM »

PVL is a full ignition system, being an internal rotating flywheel, which dramaticly reduces weight causing a ZERO flywheel effect, which means no torque but explosive top-end power and huge over revs. The kit consists of a Entire Stator System, Including Rotor, CDI, Coil, ect. ect. It is pretty d**n easy to install except getting the timing right was a bitch. You need a dial indicator. I would richen the top-end by huge amounts because of the over rev. You can put it on a stock motor. It costs around $500. Totally worth it if you are into flat out explosive power (very scary but very fun

)

delusionised · « **Reply #2 on:** June 22, 2005, 12:19:21 PM »

Thanks Gowen, Im not so sure about the no torque thing, I like torqe for climbing and lugging around the Dunes, but explosive power sounds so tempting, any way to retain torque and have explosive power?

Arigato · « **Reply #3 on:** June 23, 2005, 05:11:25 AM »

Have a few ounces shaved off your stock flywheel.

jonnoGSXR1000 · « **Reply #4 on:** April 25, 2011, 03:19:59 AM »

I've found since adding the pvl to the kx it makes it a bitch to start hot or cold.

Author Topic: PVL ignition (Read 2357 times)

delusionised

delusionised