« previous next »
Pages: [1]   Go Down

Author Topic: kx 60 port map  (Read 4632 times)

0 Members and 1 Guest are viewing this topic.

Offline jonny500

  • Hero Member
  • *****
  • Posts: 580
kx 60 port map
« on: July 19, 2010, 04:23:41 AM »
just wondering if any of you guys have a port map for a kx 60, or if you know the transfer and exhaust duration. failing that if someone could measure the distance from the top of the cylinder to the top of the exhaust port and transfer. any help would be greatly recieved
best regards
john
Logged

Offline Coop

  • Full Member
  • ***
  • Posts: 107
Re: kx 60 port map
« Reply #1 on: July 19, 2010, 04:35:40 AM »
I have the bad cylinder here off the KX60 I just rebuilt. I can get that measurement for you.

Edit: Just went outside, that measurement is surprising hard to get, LOL. My micrometers are all too big to fit into the cylinder, so I tried to use the depth gage on my calipers. I couldn't really it in through the port from the outside with anything to use as a stop so I measured a few times and "eyeballed it" and consistently got around .865-.867".

« Last Edit: July 19, 2010, 05:05:05 AM by Coop »
Logged
"Twenty years from now, you will be more disappointed by the things that you didn't do than by the ones you did do"- Mark Twain

1997 CR80RB, 1993 KX60, 1988 KX125

Offline jonny500

  • Hero Member
  • *****
  • Posts: 580
Re: kx 60 port map
« Reply #2 on: July 19, 2010, 05:23:49 AM »
thanks coop eyeball is fine. i am porting a 50cc bike at the minute and its not going well. just thought i would compare with a competition engine to see if i was in the right ball park
Logged
Pages: [1]   Go Up
« previous next »