Starting to look like a bike. Luckily I was able to spin the shock reservoir down to miss the pipe but still also be clear of the shock. I need to figure out something for the silencer mount. If I use the mounting points on the frame and silencer, the silencer just goes into the pipe. If I fully fit the silencer into the pipe, it is about 1.5" too short to reach the frame mount. Maybe a short tab with two holes drilled, think that will be stiff enough? That or maybe bolt it to the frame, but use a short section of heater hose and two clamps to seal the lose pipe/silencer joint. I also need to get a pipe spring, the one from the stock pipe is too long, it hooks on with no tension, LOL. I think I'd like to find a sticker that says "60" to put where my brother stuck that green/black "KX" sticker. The wheels will be on tonight or tomorrow, then it's just get a couple of perches and it's done. The front tire has some cracks in it, but has been holding air since yesterday. So I am using it for now. I am excited to hear it run. I could start it now, but I want to wait until it's rolling.
