« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: Bike won't start!  (Read 7836 times)

0 Members and 1 Guest are viewing this topic.

Offline Goat

  • Hero Member
  • *****
  • Posts: 785
  • Ride it like you stole it!
Re: Bike won't start!
« Reply #30 on: April 27, 2010, 02:42:36 PM »
They should be able to get most if not all the bearings for you. Just make sure they are high speed bearings and are not sealed. It will be considerably cheaper to go through the bearing shop rather than Kawi. But that is your choice.

I haven't used the Moose gasket and seal kit on the K5 yet but have on other bikes and it is a great kit. Good gasket material and seals look just as good as factory seals. Didn't find any on ebay but It was about $80 USD at the dealer when I checked a couple months ago.
Logged
Quote from: Danger4u2 on June 17, 2010, 01:36:16 AM
It's hard to keep a drivers license riding a 2 stroke dirt bike on the street.  If you drive within the law they are VERY boring.

Offline snoopjonnyjon

  • Sr. Member
  • ****
  • Posts: 276
Re: Bike won't start!
« Reply #31 on: April 28, 2010, 02:21:25 AM »
I have used both a Winderosa and a Moose gasket/seal kits. There were some differences in the gaskets from OEM Kawi, but the seals were identical NTN seals.
Logged

Offline bob larry

  • Full Member
  • ***
  • Posts: 150
Re: Bike won't start!
« Reply #32 on: April 28, 2010, 08:02:52 AM »
Thanks.

I got a Moose gasket set on ebay for $60 shipped
and Oil Seals for $20 shipped

www.canadianbearing.com is my bearing hook up

Got my flywheel puller and vaccum/comp. gauge kit too....

Ready to roll.  Taking the Jug and piston to NRCracing Saturday morning for mail out.

Taking the bottom end out tn and start the tear down.

Thanks for all the help so far....uguys are great.

 :mrgreen:
Logged
2001 KX500
Pages: 1 2 [3]   Go Up
« previous next »