« previous next »
Pages: 1 [2]   Go Down

Author Topic: cold start issues  (Read 4787 times)

0 Members and 1 Guest are viewing this topic.

Offline fluffy

  • Full Member
  • ***
  • Posts: 78
Re: cold start issues
« Reply #15 on: March 15, 2010, 12:08:43 PM »
1989 stock 500,dont touch the gas,pull up the choke,kick it 7 or 8 times starts every time. has to warm up at least 5-6 minutes at least before i can get it off the ground.
Logged

Offline 98kaw500rider

  • Jr. Member
  • **
  • Posts: 44
Re: cold start issues
« Reply #16 on: March 16, 2010, 10:55:55 AM »
This is how i start my 98 k5 . Choke and gas on , hold the kill switch in and kick her 3-4 times like your trying to start it . Let go of the killswitch and find top center and boot her , mine fires up in 1-3 kicks everytime.
Logged

Motorrad

  • Guest
Re: cold start issues
« Reply #17 on: March 16, 2010, 01:27:26 PM »
I still say low on compression... My 87 was exactly the same.   New rings cured it.  Would have to be dragged when cold, after lit it would be good till the next time it sat for more than 4 hours or so....
Logged

Offline kawi4ever

  • Jr. Member
  • **
  • Posts: 36
Re: cold start issues
« Reply #18 on: March 16, 2010, 02:34:14 PM »
Hi wanted to also agree with stewart that its most likely your crank seals, they are not alowing a proper vacuum when cold to suck the fuel in  and causing a lean backfire out of the exhaust. Hope this helps  :-D
Logged

Offline danimal

  • Jr. Member
  • **
  • Posts: 11
Re: cold start issues
« Reply #19 on: March 18, 2010, 02:35:27 AM »
thanks for all the help guys,unfortunatley i leave for little sahara ok next week,so i wont be have time to do a vacuum test until i get back,i will keep you guys updated.....Also Stewart expect a pm from me for port work when i get back as well :evil:tahnks again
Logged
Pages: 1 [2]   Go Up
« previous next »