Author Topic: General questions and advice..  (Read 7618 times)

0 Members and 1 Guest are viewing this topic.

Offline Lawnmowerman

  • Full Member
  • ***
  • Posts: 50
Re: Year??
« Reply #15 on: January 08, 2010, 10:17:04 AM »
I did strange things before.. This is just a new project.
I did a couple of years of moped dragracing. Used a Puch Maxi single speed engine.
Made a Kawa KX85 cilinder on the origanal engine. Did 0 to 60 miles in 6.7 seconds..
Used a 85 cilinder because of the regulations that it's max 80cc with the origenal stroke of the engine.
Puch stroke is 43mm and with the 48.5mm bore made it close to 80.

Engine with a Ignitech programable ignition.
http://i29.tinypic.com/331dk3t.jpg
Youtube with homemade chassis..
http://www.youtube.com/watch?v=qmkk-B97D6Y
Complete homemade cilinderhead.
1
http://i41.tinypic.com/o7m05e.jpg
2
http://i43.tinypic.com/a2w32w.jpg
Because of the huge transfers i needed to weld a 3cm thick plate on the engine.
http://i41.tinypic.com/5f2czs.jpg
http://i44.tinypic.com/2vnndb8.jpg
« Last Edit: January 08, 2010, 09:27:19 PM by Lawnmowerman »

Offline DoldGuy

  • Hero Member
  • *****
  • Posts: 1,198
Re: Year??
« Reply #16 on: January 08, 2010, 12:49:50 PM »
You might be a Redneck if?   :-D
Its Never too Late to Have a Happy Childhood!

Offline GDubb

  • Sr. Member
  • ****
  • Posts: 434
Re: Year??
« Reply #17 on: January 08, 2010, 01:38:52 PM »
I aint never seen no darned redneck with a diggity danged 'ol dragster moped you had to tune with one of those newfangled laptop computer contraptions...  8-)


-G
Rock it 'til the wheels fall off!

"It's not what you ride... It's who you're riding for!" - www.mxrevelation.com -

Offline demographic

  • Hero Member
  • *****
  • Posts: 825
Re: Year??
« Reply #18 on: January 13, 2010, 01:56:43 AM »
Brilliant, keep the pictures coming.

Offline Lawnmowerman

  • Full Member
  • ***
  • Posts: 50
Re: Question..
« Reply #19 on: March 02, 2010, 12:04:55 AM »
Yesterday the cylinder returned from Powerseal. Powerseal in the Netherlands to be precise.
Looks nice...


Now it's time to put the engine back together and calculate and cast a new cylinderhead. Were are going to use a 10mm sparkplug to minimize the disturbance. And we make sure there is room for the decompression valve.


Question..
I need a exhaust. One that's good in midrange and top-end.
What to get????
Low-end isn't that important. There wil be enough left to flip me over i think.  :-D