« previous next »
Pages: [1]   Go Down

Author Topic: Float height  (Read 2840 times)

0 Members and 1 Guest are viewing this topic.

kiro29

  • Guest
Float height
« on: February 07, 2004, 06:06:16 AM »
Hi,

I'm a litlle confuse, float height is the full movement of the float (from empty bowl until the valve pin closes) or it's the gap between the float and the valve pin when the bowl is full until it starts to fill again???

Thanks

Miguel
Logged

kawdude

  • Guest
Float height
« Reply #1 on: February 07, 2004, 01:36:13 PM »
If you hold the carb upside down.  Its the measurment from the top of the float to the lip where the bowl attaches.  15-16mm
Logged

mikesmith

  • Guest
Float height
« Reply #2 on: February 08, 2004, 08:14:26 AM »
Balance the needle so it just starts to seat,and measure the carb body(as Kawdude wrote where bowl attaches to the carb body)to the bowl arm(seam in float).
Logged

kawdude

  • Guest
Here's a good example
« Reply #3 on: February 08, 2004, 10:51:57 AM »
Thanks mikesmith your response sounded more organized than mine.  Check out this link it describes what needs to be done.


http://www.dirtrider.net/justkdx/floatlevel.html
Logged
Pages: [1]   Go Up
« previous next »