Tips please

[kxracer]

Here are a couple of pictures.

The Unistrut (the straight bar) was given to me, I purchased the rods and nuts for a few dollars at a local store.
The threaded rod needs to be M6 (2 is enough) and a M8 threaded rod to push the crank out of the case.

I will type it up in the next few days as a PDF.

Hope this helps

 

[kxracer]

two pictures,

an engineering diagram (really bored at work today, so got busy on Visio!) and a picture of me using the same setup to press the cases together.

It literally took 30 seconds to press them back, completely parallel and no force.

The kit costs a few dollars or can be scrounged of a pal who works at a building site or engineering works.