« previous next »
Pages: [1]   Go Down

Author Topic: 125 problem  (Read 2777 times)

0 Members and 1 Guest are viewing this topic.

Offline 500freak

  • Full Member
  • ***
  • Posts: 53
125 problem
« on: September 09, 2009, 03:41:16 AM »
hey guy im alittle stumped. ive got an 85 kx125 it starts and revs fine but, the power valves only open in 1st and 2nd. when you hold it open it starts blown smoke real bad. i got it mixed 40-1 and, the carbs on stock settings. its a pwk 38 off a 94 250. and if your lugging it and smack it wide open it just boggs out.
Logged
87 k5 Pc pipe,v-f3,pwk....SOLD!!
87 k5 stage 3 port,torque spacer 39.5mm carb,gnarly pipe,vf reeds,uni filter,bored 86.5
99 banshee 421 stroker beast!!!
75 dt400 all stock SOLD!
85 kx125 stock

Offline Friar-Tuck

  • Hero Member
  • *****
  • Posts: 1,827
  • \o/ Live Free or Die
Re: 125 problem
« Reply #1 on: September 09, 2009, 05:55:41 PM »
500,
 is the carb jetting set up for the stock 250? 
There would be a significant difference for an application on your 125.
  (My clymer man only has 125 & 250 to '91)
I'll see if I can find specs for a 125 w/a 38mm keihin. That should get you alot closer
 (I think D'oldGuy has a Kx125 who may be able to give you some better insight.)
  Tuck\o/
Logged
"The Truth Has No Agenda"

Offline 500freak

  • Full Member
  • ***
  • Posts: 53
Re: 125 problem
« Reply #2 on: September 10, 2009, 04:14:18 PM »
yes the jetting is set for a stock 250. 
Logged
87 k5 Pc pipe,v-f3,pwk....SOLD!!
87 k5 stage 3 port,torque spacer 39.5mm carb,gnarly pipe,vf reeds,uni filter,bored 86.5
99 banshee 421 stroker beast!!!
75 dt400 all stock SOLD!
85 kx125 stock

Offline KXcam22

  • Hero Member
  • *****
  • Posts: 1,677
Re: 125 problem
« Reply #3 on: September 11, 2009, 03:41:57 AM »
Freak,
  That will be a huge issue. Too much gas for a 125. If you mimic the settings for a new 125 is should be very close. Cam.
Logged

Offline DoldGuy

  • Hero Member
  • *****
  • Posts: 1,198
Re: 125 problem
« Reply #4 on: September 12, 2009, 06:21:25 AM »
500Freak,
The jetting I use for the 38mm PWK is as follows:

170 Main
52 Pilot
# 6 Slide Cutaway
N1A1 Needle
1 1/2 Out on the Air Screw

This setup should get you very close on yours, hope the info helps! :-D
DoldGuy
Logged
Its Never too Late to Have a Happy Childhood!
Pages: [1]   Go Up
« previous next »