« previous next »
Pages: [1]   Go Down

Author Topic: KX 250 Frame swap, what are suggested parts to replace?  (Read 2321 times)

0 Members and 1 Guest are viewing this topic.

Offline kxgarage

  • Newbie
  • *
  • Posts: 3
KX 250 Frame swap, what are suggested parts to replace?
« on: July 09, 2009, 04:36:22 AM »
I recently bent/cracked my frame, and I got a newly used frame after good advice from our fellow kxriders on this site...  thanks!

My question is, What types of things should I replace during the swap? (ie bushings, hoses rubber pieces, etc)  It is a 2000 kx250 model year.  What typically fails or gets lots of wear that is an easy fix when the bike is in pieces?

Also any ideas of where I can find a listing of torque settings for the bike? (forks, engine, swingarm, etc?)

your help is greatly appreciated
Logged

Offline PowerFiend

  • Full Member
  • ***
  • Posts: 169
Re: KX 250 Frame swap, what are suggested parts to replace?
« Reply #1 on: July 09, 2009, 09:17:04 AM »
Was the old frame a 2000, and do you still have it? I need the engine cradle for a project bike if the underside of the frame rails aren't bashed up.
Logged

Offline kxracer

  • Jr. Member
  • **
  • Posts: 26
Re: KX 250 Frame swap, what are suggested parts to replace?
« Reply #2 on: July 10, 2009, 12:13:21 AM »
The Clymer manual normally has a chart at the end of each chapter with torque settings of the parts in that chapter
My KX is an 87 and happy to send them over, I dont think torque settings would change too much for the same items.

 
Logged
Pages: [1]   Go Up
« previous next »