Author Topic: Jetting for Glamis?  (Read 4371 times)

0 Members and 2 Guests are viewing this topic.

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« on: October 27, 2003, 08:37:17 AM »
Paul, What jetting shoud I use for Glamis? I have a 01 with reed spacer and the FMF Gnarly pipe.

Thanks!

Alan :D
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

Offline Paul

  • Hero Member
  • *****
  • Posts: 1,205
  • Top Dawg
    • KX Riders
Jetting for Glamis?
« Reply #1 on: October 27, 2003, 08:47:43 AM »
My setup is:

178 Main
58 Pilot
3rd clip on needle
2 turns on airscrew

a 50:50 mix of 92 and Sunoco Purple (110 octane) which yeilds 101 octane mix. Run that 40:1 with Maxima Super M

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« Reply #2 on: October 27, 2003, 08:57:43 AM »
Quote from: Paul
My setup is:

178 Main
58 Pilot
3rd clip on needle
2 turns on airscrew

a 50:50 mix of 92 and Sunoco Purple (110 octane) which yeilds 101 octane mix. Run that 40:1 with Maxima Super M
Thanks! And If I stick with my gas and oil mix 93 octane with Kawi Kem @32:1?
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

Offline Paul

  • Hero Member
  • *****
  • Posts: 1,205
  • Top Dawg
    • KX Riders
Jetting for Glamis?
« Reply #3 on: October 27, 2003, 09:03:52 AM »
Hell I don't know :lol: .

A safe rule of thumb is to go UP two main jet sizes to compensate for the harder working engine in the sand. The extra fuel / oil helps to keep the big-end bearing alive when you're on it constantly ;)

32:1?!?!?! Are you TRYING to plug that thing up :lol: That is a carry over from the air cooled days. I've run my '01 (bought Dec '00) on 50:1 since brand new, except when I go to Glamis - 40:1 then.

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« Reply #4 on: October 27, 2003, 10:49:49 AM »
You are right about the old air cooled bikes, just showing my age again! d**n :oops: I looked in my old YZ490 manual and the recommended 24:1 d**n that's almost straight oil! No wonder we fouled plugs!

When I bought the bike is was told to run 32:1, so that's what I have been using.

I used an octane booster in my YZ490 due to the high compression ratio and the detonation problem. Explain why you use the race gas mix.

Thanks?

Alan
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

Offline Paul

  • Hero Member
  • *****
  • Posts: 1,205
  • Top Dawg
    • KX Riders
Jetting for Glamis?
« Reply #5 on: October 27, 2003, 10:55:59 AM »
Because the KX500 will run ok on lower octane BUT the engine - acording to my KX500 manual, you got one to i bet :wink: - is designed to run on atleast 95 octane and prefferable 98 and up. Run something over 100 octane and the bike will show you just how powerful it really is :wink:

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« Reply #6 on: October 27, 2003, 11:48:06 AM »
Octane does not have any more power it ups the point at which the fuel will detonate under pressure on its own.

Alan :D
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

Offline Paul

  • Hero Member
  • *****
  • Posts: 1,205
  • Top Dawg
    • KX Riders
Jetting for Glamis?
« Reply #7 on: October 27, 2003, 11:52:05 AM »
This is very true... HOWEVER, detonation is the enemy of performance.

An engine designed to run on 100 octane will run on 92 but not to it's potential. I understand that 100 octane will not make your Ugo run 150 miles an hour but it will make your KX500 run cooler, last longer and not have the serious detonation problem that you are going to encounter at Glamis under serious load.

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« Reply #8 on: October 27, 2003, 12:01:50 PM »
You are absolutely correct! :D

I have seen so many post arguing about octane and how much more power it would give you!

You should read the post on YZ490.com when I sugested that using an octane boster would be a good idea! Its amazing what sets  people off! :lol:

Thanks for the advise! :)

Alan :D

PS if you get bored read this!
http://www.yz490.com/index.php?name=PNphpBB2&file=viewtopic&t=26&postdays=0&postorder=asc&start=0&sid=7ce6f03a21c5e176dee4a291aeabb7ca
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

Offline Paul

  • Hero Member
  • *****
  • Posts: 1,205
  • Top Dawg
    • KX Riders
Jetting for Glamis?
« Reply #9 on: October 27, 2003, 12:13:41 PM »
Some people :lol: Maybe that guy can't read :?

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Jetting for Glamis?
« Reply #10 on: October 27, 2003, 12:17:01 PM »
Quote from: Paul
Some people :lol: Maybe that guy can't read :?
YEP :roll:
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F