« previous next »
Pages: [1]   Go Down

Author Topic: kips  (Read 1989 times)

0 Members and 1 Guest are viewing this topic.

Offline fluffy

  • Full Member
  • ***
  • Posts: 78
kips
« on: July 15, 2007, 03:14:39 PM »
how would one tell if kips is working without tearing evering apart. i race a 89 500 on a fifth mile oval in 3 gear,really fast but them 450 are hard to get by. sprokets are 14-48.
Logged

stewart

  • Guest
Re: kips
« Reply #1 on: July 15, 2007, 03:29:00 PM »
pull  two bolt plastic side cover of base of cylinder  take 10 mm nut loose spool should slide in and out freely if it dose push spool all the way in and tighten nut  if not tear down and clean
Logged

Offline fluffy

  • Full Member
  • ***
  • Posts: 78
Re: kips
« Reply #2 on: July 16, 2007, 05:53:58 AM »
thanks stewart tonites project.
Logged

Offline fluffy

  • Full Member
  • ***
  • Posts: 78
Re: kips
« Reply #3 on: July 20, 2007, 11:53:24 AM »
stewart i did what you said, i found the governer lever on the outside of the collar not in the groove. rod moves freeley i removed the c clip and collar put the lever end where it belongs,and buttoned it up.try it tomorrow. kept wondering why everyone said hold on. maybe tomorrow ill hold on.thanks again.
Logged
Pages: [1]   Go Up
« previous next »