« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: clutch basket removal  (Read 20752 times)

0 Members and 5 Guests are viewing this topic.

Offline gwcrim

  • Hero Member
  • *****
  • Posts: 673
    • http://profiles.yahoo.com/gwcrim
Re: clutch basket removal
« Reply #30 on: February 04, 2007, 06:44:15 AM »
IT' OFF!!!

I put the hub holder on tight, applied generous amounts of heat via a map gas torch and then whacked it with my impact gun.

Of course, the hub got hot and the holder squeezed it way out of round.  In hindsight, I should have known better than to squeeze it so tightly but I was so intent on getting it off that all caution was through out.

Bike Bandit lists them at $37.  GRRRRRRRRR!!!!!!
Logged
~Crim~
You raise the blade
You make the change
You rearrange me 'til I'm sane

Team 51

  • Guest
Re: clutch basket removal
« Reply #31 on: July 20, 2007, 08:54:54 AM »
Newbie here...I am currently having a heck of a time trying to get the bolt off my sons 2004 KX65. Can you confirm that the bolt thread is not reversed? Thanks
Logged

Team 51

  • Guest
Re: clutch basket removal
« Reply #32 on: July 20, 2007, 09:30:05 AM »
Finally, it is off!!! No, it is not reversed thread to answer my own question. A ton of heat and about 110 psi on the impact wrench finally broke it loose. Great thread!!! Thanks kxriders.

I am in the process of splitting my first case to replace the lower bearing rod so I am sure I will have more questions going forward.
Logged
Pages: 1 2 [3]   Go Up
« previous next »