Author Topic: Needle jet  (Read 2532 times)

0 Members and 1 Guest are viewing this topic.

zert

  • Guest
Needle jet
« on: April 10, 2006, 03:49:22 AM »
hi,the needle in my bike is N85D.Is that thicker or thinner than the original because my k5 uses a lot of fuel at low rpm.Riding at high or low rpm,the consumption stays the same.So,if someone knows an answer,let me know.
Thanks,
Wim

Offline KXcam22

  • Hero Member
  • *****
  • Posts: 1,677
Re: Needle jet
« Reply #1 on: April 10, 2006, 04:33:04 PM »
Zert,
  Stock is an N85M which is leaner that yours, hence it has a larger diameter. Your needle is thinner than stock. The D would make it pretty rich in the midrange 1/4-1/2 throttle. Cam.

Offline Arnax

  • Jr. Member
  • **
  • Posts: 22
Re: Needle jet
« Reply #2 on: April 11, 2006, 03:02:03 AM »
Isn't N82M the stock needle?

Offline alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,476
Re: Needle jet
« Reply #3 on: April 11, 2006, 03:39:48 AM »
What years are we talking about guys?
Sand - Dirt - Dunes = Fun
       04- 700V - 01- KX500
        08 TeryX 2012 KX450F

zert

  • Guest
Re: Needle jet
« Reply #4 on: April 11, 2006, 04:25:50 AM »
sorry,'99kx

zert

  • Guest
Re: Needle jet
« Reply #5 on: April 11, 2006, 05:58:25 AM »
okay,today i Re-discovered my mean green thing.It was awesome!!! :-D.I've got him since october but something was wrong.He had a lot of power(of course,its a 500 :-))but it consumpts lots of fuel and smoked like hell.So friday i decided to take him apart because the bolt for oil draining was broken and i had a leaking gasket between the cylinder and the engine.While i was busy,i decided to clean the powervalves and checking the piston.That last item was in very good shape,but the valves needed a good checkup(special thanks to the autor of top end rebuild!).The previous owner has put the valves back with a wrong timing,there was always one exhaustport open and the upper one did'n open much.So today,after work i went to the welder for my block and put everything back together.After a few houres of work,the test moment was there.It was raining(typical belgium weather) but i did not care.After 5 times kicking,there was live.A little smoke but very good trottle respons and powerwheelies in fourth(gearing 15/42)!To make the story shorter,it was a big improvement and they may be old,but they still kicks butt :-D

Offline KXcam22

  • Hero Member
  • *****
  • Posts: 1,677
Re: Needle jet
« Reply #6 on: April 11, 2006, 08:03:03 AM »
Oops! Arnax is right. N82M is stock. Hope I didn't mislead you. Cam.