« previous next »
Pages: [1]   Go Down

Author Topic: Rad Valve to fit a 1988 Kx250  (Read 1318 times)

0 Members and 1 Guest are viewing this topic.

Offline Shane Rad-dog

  • Newbie
  • *
  • Posts: 6
Rad Valve to fit a 1988 Kx250
« on: November 21, 2021, 12:31:04 AM »
Hey guys im rebuilding a 1988 kx250 engine and the intake rubber is shot . The v force list thier reed as 87 to 2004 compatable so will the Boyesen Rad Valve be the same ?  Boyesen say on thier page that they are model specific . Or is that just so you will buy a new 1 if you swap bikes .


Cheers
Logged

Offline KXDINO

  • Hero Member
  • *****
  • Posts: 630
Re: Rad Valve to fit a 1988 Kx250
« Reply #1 on: November 23, 2021, 07:20:00 AM »
Intake rubber on kx250 88 to 90 and kdx250 91 to 94 are all the same part number 16065-1168 , later versions could have the same bolt pattern and carb angle looks different , with out having them parts lying around it hard to say,
Logged

Offline Shane Rad-dog

  • Newbie
  • *
  • Posts: 6
Re: Rad Valve to fit a 1988 Kx250
« Reply #2 on: November 23, 2021, 10:50:07 PM »
Thants a pretty good point , perimiter frames would have a differnt airbox & boot lay out perhaps. Thanks for the imput :-)
Logged
Pages: [1]   Go Up
« previous next »