« previous next »
Pages: [1]   Go Down

Author Topic: Flywheel clearance question  (Read 1812 times)

0 Members and 1 Guest are viewing this topic.

Offline Bcsnowbiker

  • Jr. Member
  • **
  • Posts: 34
Flywheel clearance question
« on: May 16, 2019, 06:55:30 AM »
Does the flywheel have enough clearance to run hex head bolts like in the bottom left corner or do I need to run the OEM Phillips like the top right bolt and deal with this on dissasemby?
It wasn't the worst easy out I've delt with but the Phillips was already stripped by previous owner.
Logged

Offline Bcsnowbiker

  • Jr. Member
  • **
  • Posts: 34
Re: Flywheel clearance question
« Reply #1 on: May 16, 2019, 07:01:08 AM »
Wrong picture
Logged

Offline 1901306708

  • Full Member
  • ***
  • Posts: 150
Re: Flywheel clearance question
« Reply #2 on: May 17, 2019, 01:48:15 PM »
I use an 8mm hex on mine and nothing rubs. I have a pvl ignition though
Logged

Offline Bcsnowbiker

  • Jr. Member
  • **
  • Posts: 34
Re: Flywheel clearance question
« Reply #3 on: May 17, 2019, 04:24:44 PM »
Thanks
I will have to look more into the pvl ignition....
Logged

Offline 1901306708

  • Full Member
  • ***
  • Posts: 150
Re: Flywheel clearance question
« Reply #4 on: May 19, 2019, 07:33:01 AM »
its ok. nothing to get too excited about. don't get it wet, which is hard to do on a snowbike.
Logged

Offline Bcsnowbiker

  • Jr. Member
  • **
  • Posts: 34
Re: Flywheel clearance question
« Reply #5 on: May 20, 2019, 01:26:58 PM »
I have to dry my ignition after every ride from condensation
Logged
Pages: [1]   Go Up
« previous next »