Hallo all. My KX is pretty much all there, pretty much in original condition and trim, but every nut and bolt that has been taken off must've got lost. They've been replaced with anything that "fits" - in other words forced and bodged into place. A lot of them were very difficult to remove, and most of the threads are damaged. The first thing I have to do, to get mine back up and road/off road worthy, is replace all them all. Some firms used to do kits - for instance a kit containing all the bolts needed to rebuild an engine using Allen screws. Of course I'm sure I could get every one OEM but that'd cost a fortune.
I need virtually every nut, bolt and washer to replace the tank, all the plastics that screw into the tank, the radiator, the subframe etc. also to mount the exhaust. Luckily, all the ones in the engine are fine.
What does everyone use? What's best? Do you use Allen screws? Is the thread size standard metric? All the threads need to be tapped, or perhaps have inserts fitted, but I have to do this right as I intend to cover a lot of ground on the KX and shall be using it as daily transport.
1st PHOTO:Here is a picture of ALL that I have:
2nd PHOTO: Edit to post. I have found this on eBay at about $US 50. Anyone bought these? If so, are they the right ones, fit OK, any feedback?