Hey guys. My bike has a new set of Barnett dirt digger clutches in it, with fairly low hours on them. And the clutch has always worked fine. But all of a sudden, i have very minimal clutch pull. Almost like the cable is stretched. I have one of those nice quick adjusters on the handle. (ASV?) and i ran it all the way out, and still wont go in neutral.
Thing is... there is a LOT of free play & lost motion at the actuator lever. I took it all apart, and the plates and fibers seem to be fine. The ball is still in there, the rod and the little pusher thing at the hub all look good as well.
Also there is NO BOLT to hold the actuator down in the case. There is a place where it should be, but its like it was never drilled or tapped from the factory. How about the little needle bearing in there? Do these ever get worn out? Is there only supposed to be one? The needles are all still in it so i assume its ok, but man its all really loose.
Iduno im at a loss.