« previous next »
Pages: [1]   Go Down

Author Topic: How do you clean your pipe?  (Read 5144 times)

0 Members and 1 Guest are viewing this topic.

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
How do you clean your pipe?
« on: November 09, 2017, 03:38:11 PM »
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Heniz

  • Full Member
  • ***
  • Posts: 68
Re: How do you clean your pipe?
« Reply #1 on: November 09, 2017, 05:29:35 PM »
Awesome I will keep an eye out for these!!!

I normally sandblast it torch the welds and coat it in high temp clear  :x

DEP factory pipe
Logged
Moto is life

Offline motopunk

  • Hero Member
  • *****
  • Posts: 1,150
    • www.der-motopunk.de.tl
Re: How do you clean your pipe?
« Reply #2 on: November 09, 2017, 07:30:55 PM »
steelwire wheel , 3m scotchbrite pad and wd40 ...   but there is a good way to prevent this bad rusty conditions..   spray it with wd40 or better put weapon-oil on it with a towel after every ride and clean ...my dep-works-pipe had a interesting llightbrown patina by the time   :wink:
Logged
big 2 stroke bikes are weapons for real men, who don´t fear death or devil. ;O)
´83 kx250, ´87 kx250 (with 360 big bore), 87 kx500, ´93 kx500 sfc

---  www.der-motopunk.de.tl  ---

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: How do you clean your pipe?
« Reply #3 on: November 10, 2017, 02:04:42 AM »
Nice guys!  8-)
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Ims Roll

  • Sr. Member
  • ****
  • Posts: 315
  • Ride safe, Ride hard
Re: How do you clean your pipe?
« Reply #4 on: November 10, 2017, 02:49:41 AM »
Steel with rust from the inside out if you clear coat it... Not a super good idea. But nothing beats elbow grease and hardwork with some scotch bright to make a pipe shine.
Logged
The 2-smoke runs deep in this one...

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: How do you clean your pipe?
« Reply #5 on: November 11, 2017, 01:21:05 AM »
I usually pull out the wallet and buy a nice shiny new one...can't get a much better look....and no "elbow grease" required.  :mrgreen:
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: How do you clean your pipe?
« Reply #6 on: November 11, 2017, 01:49:25 AM »
Lol.... Yeah, it's hard to beat a new pipe...
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: How do you clean your pipe?
« Reply #7 on: November 11, 2017, 02:04:56 AM »
...lol A-men

I do use a scotch-brite pad and lightly go over em with a lil WD on occasion though...but scotch-brite pads and steel wool actually dulls the finish if used constantly...so I try to keep it to just a damp cloth and wipe off the dirt.
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: How do you clean your pipe?
« Reply #8 on: November 12, 2017, 03:30:44 AM »
My pipes look good for years.
How?
I store inside where it is dry.
I'm not a rock hopper  :-o
When done riding, I wash my bike, dry the pipe, then wipe it down with wd-40.
Sure, it smokes a bit on start up but it's a smoker right?  :lol:
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: How do you clean your pipe?
« Reply #9 on: November 12, 2017, 03:35:48 AM »
+1
my fmf has been on my 500 for 5 years now...zero dents, zero rust....the PC on my 250 is exactly the same way after 4 years.





Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: How do you clean your pipe?
« Reply #10 on: November 12, 2017, 03:41:38 AM »
Here was my last K5 right before it was stolen.
That's 12 years old..

Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: How do you clean your pipe?
« Reply #11 on: November 12, 2017, 03:50:19 AM »
cool...I can guarantee mine'll look like that in another 6-7 years too

not to get off topic, but...
what I'm really amazed at...is how awesome the SuperSprox I threw on 3 years ago are holding up!!!....there's absolutely no wear on either of them.
Alward25 was right when he said I'd never have to buy another rear sprocket!
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ
Pages: [1]   Go Up
« previous next »