« previous next »
Pages: [1]   Go Down

Author Topic: 48mm fork conversion on my 96  (Read 2324 times)

0 Members and 1 Guest are viewing this topic.

Offline Teamcraig

  • Newbie
  • *
  • Posts: 4
48mm fork conversion on my 96
« on: October 18, 2017, 11:31:33 PM »
My question is if the a perimeter frame kx250 triple clamp set will fit on my kx 500? I'm wanting to put my 12 450 forks on my 500. Or does anyone have a 97-04 500 triple clamp set they want come off of? I cannot afford the pricy Emig racing setup.
Logged

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: 48mm fork conversion on my 96
« Reply #1 on: October 19, 2017, 03:16:04 AM »
The top bearing on the 250 is larger then the 500.
The 97-04 KX500 triples are a little tight but you can loosen them up with a drum sanding wheel.
Several people run them without sanding them but it could technically create some pinch points.

http://www.oem-cycle.com/forum/viewtopic.php?f=116&t=1331
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.
Pages: [1]   Go Up
« previous next »