Author Topic: What carb should I put on my KX500?  (Read 7777 times)

0 Members and 1 Guest are viewing this topic.

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
What carb should I put on my KX500?
« on: April 29, 2017, 03:38:24 AM »
Looking at Roostius's flow bench numbers and info gathered from Kawasaki Team Green Mechanics we have come up with the following..

96-97 KX250 or a 2000 Cr250 carb.
Or you can go to Sudco and get a Keihin Quad vent Air striker 38mm for about 200.

You can use the newer Airstrikers as well but you need to block off a few things.

It will add 1 hp to the rear wheel on a completely stock KX500.. That is dyno confirmed.

The flow bench shows that it does just as well as a 41mm Airstriker for volume and velocity.   That is also dyno confirmed...
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #1 on: April 29, 2017, 03:40:31 AM »
We need to come up with some decent jetting specs.

Sean Colliers bike.
pilot 55
main 175
16009-1613 NEEDLE-JET N89D - 2nd position
Slide 7

We ran this at Glen Helen 1700-1800 ft.. 50% C12 and 50% 91 California pump gas.

You will need the correct throttle and cable for which carb you choose.
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline KXDINO

  • Hero Member
  • *****
  • Posts: 630
Re: What carb should I put on my KX500?
« Reply #2 on: April 29, 2017, 10:42:45 AM »
shows you bigger is not allways better.

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #3 on: April 29, 2017, 11:08:08 AM »
 :-D
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline chipped tooth

  • Jr. Member
  • **
  • Posts: 48
Re: What carb should I put on my KX500?
« Reply #4 on: April 29, 2017, 12:18:04 PM »
Lectron 44+ stock 500?

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #5 on: April 29, 2017, 12:57:06 PM »
I've never ran one.
I don't know anyone else who has ran one that big on a stock K5 either.
My guess is you would loose velocity and kill off the bottom end.
I could be wrong...
I actually have a 44 but I'm saving mine for something a bit more exotic :-)
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline umberto

  • Administrator
  • Hero Member
  • *****
  • Posts: 2,488
  • First Ride 02-02-19
Re: What carb should I put on my KX500?
« Reply #6 on: April 29, 2017, 02:02:52 PM »
I don't know anyone else who has ran one that big on a stock K5 either.
I guess mine is pretty close to stock, with only the bigger bore.  Fl_Sharpshooter is also running a 44 Lectron on his with a fairly stock motor.  I don't have much to compare it to, but it does a pretty good job of responding down low compared to my worn out stock carb.
Perhaps I have a dirt bike addiction?

03 KX 250/88 KX 525/2017 KX250F - Goliath
17 KX250F/04 KX250
04 KX 250 - Lunchbox's Bike
05 KX 125/144

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #7 on: April 29, 2017, 04:09:31 PM »
Dyno time :-)
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline umberto

  • Administrator
  • Hero Member
  • *****
  • Posts: 2,488
  • First Ride 02-02-19
Re: What carb should I put on my KX500?
« Reply #8 on: April 29, 2017, 04:20:24 PM »
Dyno time :-)
I wish I knew where one is near me. I would love to know what Goliath puts out.
Perhaps I have a dirt bike addiction?

03 KX 250/88 KX 525/2017 KX250F - Goliath
17 KX250F/04 KX250
04 KX 250 - Lunchbox's Bike
05 KX 125/144

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #9 on: April 29, 2017, 06:27:15 PM »
Oklahoma city has several  :-o
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline umberto

  • Administrator
  • Hero Member
  • *****
  • Posts: 2,488
  • First Ride 02-02-19
Re: What carb should I put on my KX500?
« Reply #10 on: April 30, 2017, 10:04:42 AM »
I may have to do that.  I'll try to borrow a stock carb from Danger to see what the difference is.
Perhaps I have a dirt bike addiction?

03 KX 250/88 KX 525/2017 KX250F - Goliath
17 KX250F/04 KX250
04 KX 250 - Lunchbox's Bike
05 KX 125/144

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: What carb should I put on my KX500?
« Reply #11 on: April 30, 2017, 12:41:45 PM »
If you end up doing it, let me know and I will see if I have a Quad vent air striker to send you...
It would be cool to see you duplicate our dyno info.
Also, what reed are you running?
If it's a VF2, try the low tension settings as well as the high tension settings.
You may get another surprise..
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline 1901306708

  • Full Member
  • ***
  • Posts: 150
Re: What carb should I put on my KX500?
« Reply #12 on: August 27, 2017, 02:36:48 PM »
a 44 lectron picks up 2 all the way through the rev range vs the bored 39 kehin on a stockish bike. measured at the front sprocket.