Author Topic: Bottom end flush?  (Read 1766 times)

0 Members and 1 Guest are viewing this topic.

afritts4u

  • Guest
Bottom end flush?
« on: September 19, 2005, 10:59:14 AM »
I have my top end off, being replated. I noticed some burnt on oil on the crank and rod. Had a lot of blow by due to cracked intake bridge in cylinder.

Is it advised to use water or any other solvent to flush out the bottom end while I have easy acess. Of course to prevent rust ext I would need to thouryly dry and seal before I Put it back together and reseal the engine. As long as I dont use too much pressure it seems like a good opportunity to get any gunk out of the crank area before it all goes back together???

Any advice tips on this??

Offline KXcam22

  • Hero Member
  • *****
  • Posts: 1,677
RE: Bottom end flush?
« Reply #1 on: September 19, 2005, 02:38:32 PM »
AF,
  I would say don't flush. You risk washing and crud into the bearings. What I do is to take small rags dipped in solvent and clip them to a long pair of hospital type forceps (the kind you take fishhooks out with), then reach in and wipe around.  It is a slow process but with some patience you can do a good job. Hope this helps. Cam.