« previous next »
Pages: [1]   Go Down

Author Topic: 250 cylinderhead squish  (Read 2083 times)

0 Members and 1 Guest are viewing this topic.

Offline SOHC

  • Full Member
  • ***
  • Posts: 119
250 cylinderhead squish
« on: December 10, 2015, 08:36:19 AM »
I have a 1990 kx250 that i have just rebuilt the engine, i checked the piston to head squish and it has only 0.43mm including the gasket, i had the cylinder bore re plated and they refaced the cylinder deck so that must have decreased the clearance a bit, also the head has been planed at some stage in its life.

What should the clearance be?
are they any good mods to do when I take it to be re mechained?
Logged

Offline LukeG

  • Full Member
  • ***
  • Posts: 166
Re: 250 cylinderhead squish
« Reply #1 on: December 10, 2015, 10:13:39 AM »
I was told by to aim for 0.75-1mm squish. You may need another base gasket.
Logged
1990 KX250 - Wanna be road racer!
2007 DRZ 462 Motard

Offline SOHC

  • Full Member
  • ***
  • Posts: 119
Re: 250 cylinderhead squish
« Reply #2 on: December 10, 2015, 05:51:52 PM »
Cool thank you, I am going to try another head as I think mine has had the holey s**t planed out of it.


I can't seem to find the info for a 1990, they say if you get the squish right they go very well
Logged
Pages: [1]   Go Up
« previous next »