« previous next »
Pages: [1]   Go Down

Author Topic: Crank outer width across flywheels for rebuild KX250 1999  (Read 2353 times)

0 Members and 1 Guest are viewing this topic.

Offline toecutter

  • Newbie
  • *
  • Posts: 8
Crank outer width across flywheels for rebuild KX250 1999
« on: September 22, 2015, 04:17:15 AM »
Currently rebuilding my 1999 KX250.

When I pressed apart the crank I forgot to take an overall outer width of the flywheels.

Does anyone know what it should be?

The manual only states the side clearance for the rod, is it OK just to use that?

Thanks
Logged

Offline dave916

  • Hero Member
  • *****
  • Posts: 546
Re: Crank outer width across flywheels for rebuild KX250 1999
« Reply #1 on: September 22, 2015, 10:07:16 AM »
Once side clearance on the rod is set/ overall outer width of flywheels should be correct if you used correct rod kit
Rod kit {different brands} can vary a little but rod side clearance is the important bit to get right 
Logged

Offline toecutter

  • Newbie
  • *
  • Posts: 8
Re: Crank outer width across flywheels for rebuild KX250 1999
« Reply #2 on: September 25, 2015, 06:23:25 AM »
Thanks, hopefully get it back together tomorrow.
Logged
Pages: [1]   Go Up
« previous next »