« previous next »
Pages: [1]   Go Down

Author Topic: New piston  (Read 3030 times)

0 Members and 1 Guest are viewing this topic.

Offline GRARA

  • Full Member
  • ***
  • Posts: 69
New piston
« on: September 14, 2015, 08:52:03 AM »
Quick question.....Ive just fitted a new piston to my 98 KX250,Ive fitted a larger piston than the last one that was in it because there was too much play....ive ran the bike in correctly but it gets spluttery at high revs and doesnt seem to have the same power...do i have to play around with the carb now that its got a slightly bigger piston?
Logged

Offline Candyman

  • Full Member
  • ***
  • Posts: 99
  • I love hot zombie chicks
Re: New piston
« Reply #1 on: September 14, 2015, 04:27:27 PM »
Wow.... where to begin....
How did your bike run before the piston replacement?
Logged

Offline GRARA

  • Full Member
  • ***
  • Posts: 69
Re: New piston
« Reply #2 on: September 14, 2015, 10:08:29 PM »
Bike was running absolutely spot on...no problems whatso ever
Logged

Offline Candyman

  • Full Member
  • ***
  • Posts: 99
  • I love hot zombie chicks
Re: New piston
« Reply #3 on: September 15, 2015, 02:53:34 AM »
How much bigger is the new piston?
Did you have the cylinder plated, sleeved, or bored?
Logged

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: New piston
« Reply #4 on: September 15, 2015, 07:31:06 AM »
ring end gap...piston to cylinder clearance, were these checked?
Logged
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Motorrad

  • Guest
Re: New piston
« Reply #5 on: September 15, 2015, 08:26:55 AM »
Quote from: Foxx4Beaver on September 15, 2015, 07:31:06 AM
ring end gap...piston to cylinder clearance, were these checked?

+1
Logged

Offline GRARA

  • Full Member
  • ***
  • Posts: 69
Re: New piston
« Reply #6 on: September 15, 2015, 09:30:53 PM »
right here goes......i removed my barrel yesterday and found that part of the powervalve system (the flappy bit you can see when you remove the exhaust) has been hitting the piston!!!! Not sure how this is even possible. Ive further been told that my barrel needs a re-plate.
The new piston ( i think ) was a size C?
Logged
Pages: [1]   Go Up
« previous next »