« previous next »
Pages: [1]   Go Down

Author Topic: clutch cover install? govenor arm?  (Read 3075 times)

0 Members and 1 Guest are viewing this topic.

Offline alexander-vmann

  • Sr. Member
  • ****
  • Posts: 412
clutch cover install? govenor arm?
« on: July 22, 2015, 07:09:42 AM »
i took the clutch cover off today to change the plates and i discorverd that the arm that comes up and out of the cover ( this is the govenor arm if im correct) was lying on the outside (furthes away from cylinder) of the pin with two disc that go into the cylinder (someting to do with the powervalves im sure) now to me it seems more logical that the arm should be in between the two discs? so that it can push back AND forth?

any answers or pictures of how this should be is greeatly appriciated!
Logged
KX 500 newbie

my bike: 1993 kx500

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: clutch cover install? govenor arm?
« Reply #1 on: July 22, 2015, 10:00:34 AM »
That is correct.... The arm must be between the two plates.
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline alexander-vmann

  • Sr. Member
  • ****
  • Posts: 412
Re: clutch cover install? govenor arm?
« Reply #2 on: July 22, 2015, 10:02:55 AM »
Quote from: sandblaster on July 22, 2015, 10:00:34 AM
That is correct.... The arm must be between the two plates.

migth this be why the bike never seems to ''kick in'' at higher revs?
Logged
KX 500 newbie

my bike: 1993 kx500

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: clutch cover install? govenor arm?
« Reply #3 on: July 22, 2015, 01:06:11 PM »
Most likely...
It certainly wasn't helping you at all...
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline alexander-vmann

  • Sr. Member
  • ****
  • Posts: 412
Re: clutch cover install? govenor arm?
« Reply #4 on: July 22, 2015, 02:15:40 PM »
Quote from: sandblaster on July 22, 2015, 10:00:34 AM
That is correct.... The arm must be between the two plates.

like this?
Logged
KX 500 newbie

my bike: 1993 kx500

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: clutch cover install? govenor arm?
« Reply #5 on: July 22, 2015, 05:20:27 PM »
Si, Bueno
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.
Pages: [1]   Go Up
« previous next »