Author Topic: Spur Gear Bearing help? W/picture  (Read 2327 times)

0 Members and 1 Guest are viewing this topic.

Offline budryzer

  • Newbie
  • *
  • Posts: 6
Spur Gear Bearing help? W/picture
« on: April 07, 2015, 08:44:30 AM »
Greetings All,
   I have a manual and I used the search feature but I'm in need of a link.  Milky Oil, so I checked and found this groove in my spur gear shaft.  I ordered two new bearings, shaft and seals.  My question is my manual doesn't show this '93 type of install.  Do I install the bearings in the case and then press in the spur gear?  It appears that my existing spur gear is a tolerance fit.....   Also, I should have two seals and two bearings, correct?
Any link to a thread on this would be helpful to me.

Thanks



« Last Edit: April 07, 2015, 11:49:25 PM by budryzer »

Offline budryzer

  • Newbie
  • *
  • Posts: 6
Re: Spur Gear Bearing help? W/picture
« Reply #1 on: April 13, 2015, 06:26:26 AM »
Well, I got the seal.  It's just one wide seal, that is open on each side to keep one fluid away from the other.  They don't play well together :-o
Bearings and spur should arrive this PM in the mail.

My mailman shows up after 5pm here.......

Offline dave916

  • Hero Member
  • *****
  • Posts: 546
Re: Spur Gear Bearing help? W/picture
« Reply #2 on: April 13, 2015, 09:18:33 AM »
Marking {writing] on seals towards the bearings
Make sure to grease seal lipps

Offline budryzer

  • Newbie
  • *
  • Posts: 6
Re: Spur Gear Bearing help? W/picture
« Reply #3 on: April 13, 2015, 09:59:21 AM »
Yup, Thanks.  Just put it in.  New spur and bearings as well.  Should put the bike back together tomorrow:)