Thanks guys. I'm very stoked on the gun metal, it looks great. A big problem I came across last night is they didn't mask off the bold holes for the rear brake line, chain slider and the plates that go on the inside of the swing arm where the axle goes through.
I struggled for ages trying to get the bols in but they just wont go in. Also as I mentioned in my previous post, they didn't do a great job of masking the bearing areas either, but not as bad as the bold holes though. I am pretty irritated about that, especially after asking them twice to make sure it is all masked off well.
Anyway, should I just tap the bold holes and sand the bearing areas? I've read up about thread chasers last night, but not sure I will be able to get a hold of that so easy. Is there any advice you guys can give me from similar experiences?
Hey 81cr450, thanks for the advice. We don't have Walmarts here in SA though, and I also think all of the foam need to be replaced since it hasn't been replaced since 99 and it's about as thin as a as a sponge. I got a quote from a guy to do foam and recover for a good price here. Will give him a try when I get to the seat.